Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
MTX Thunder 500.1 Protect Mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="yotehunter422" data-source="post: 8512022" data-attributes="member: 670374"><p>I've got an MTX 500.1 connected to my stock head unit that will not come out of protect mode. Worked flawlessly for years until I had some recent battery issues and shorts in my headlights. Resolved that and still can't figure out my amp.</p><p></p><p>The amp is getting 12.5 to the terminals. Ground and all fuses are good. Disconnected speaker and RCA cables and it still will not power on. Remote turn on is also receiving proper voltage. Any ideas?</p></blockquote><p></p>
[QUOTE="yotehunter422, post: 8512022, member: 670374"] I've got an MTX 500.1 connected to my stock head unit that will not come out of protect mode. Worked flawlessly for years until I had some recent battery issues and shorts in my headlights. Resolved that and still can't figure out my amp. The amp is getting 12.5 to the terminals. Ground and all fuses are good. Disconnected speaker and RCA cables and it still will not power on. Remote turn on is also receiving proper voltage. Any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
MTX Thunder 500.1 Protect Mode
Top
Menu
What's new
Forum list
