Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
MRD-M605 error
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Bluecamry" data-source="post: 2815387" data-attributes="member: 574942"><p>So a few nights ago, my Alpine MRD-M605 amp started blinking "CUR" for excessive current. After looking online and testing in my garage until 2am, I thought I had it fixed. It plays (somewhat) at VERY low volumes. I checked the sub, it all looks good, I rewired the wires going to the box, rerouted them to avoid pinching, and all that I havent considered is fuse (dont have the tools... but im going to see, since I cant tell if its blown or not) and the ground. im about to head out now and check the ground, and then run to car audio express and see what they think, then perhaps best buy and some other places, to get some opinions. I want this fixed, and dont know what the matter is!</p><p></p><p>Any help is greatly appreciated.</p></blockquote><p></p>
[QUOTE="Bluecamry, post: 2815387, member: 574942"] So a few nights ago, my Alpine MRD-M605 amp started blinking "CUR" for excessive current. After looking online and testing in my garage until 2am, I thought I had it fixed. It plays (somewhat) at VERY low volumes. I checked the sub, it all looks good, I rewired the wires going to the box, rerouted them to avoid pinching, and all that I havent considered is fuse (dont have the tools... but im going to see, since I cant tell if its blown or not) and the ground. im about to head out now and check the ground, and then run to car audio express and see what they think, then perhaps best buy and some other places, to get some opinions. I want this fixed, and dont know what the matter is! Any help is greatly appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
MRD-M605 error
Top
Menu
What's new
Forum list
