Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Mono split to stereo?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="cbrrocketrdr" data-source="post: 2375333" data-attributes="member: 571988"><p>I have an Audiobahn A8000T...its a MONO channel amp.</p><p></p><p>specs are:</p><p></p><p>400 watts RMS @ 4ohm load</p><p></p><p>800 watts RMS @ 2ohm load</p><p></p><p>now I have a Treo Engineering 15" sub...its a DVC 2ohm...now technically im only allowed to wire the sub to a 4ohm load for the amp to read. but id like to get 800rms...now here's my question. can i run 2 positive wires from the amp positive to each positive coil on the sub and 2 negative wires from the amp negative to each negative coil? my theory is it would still read a 2ohm load and since both coils are hooked up it would split the power, thus putting 400rms to EACH COIL/ 800RMS total to the subwoofer....any input on this? if not possible no biggy i have a DVC 4ohm sub on the way that i can wire to 2ohm load but i wanted to run my treo in the mean time.</p></blockquote><p></p>
[QUOTE="cbrrocketrdr, post: 2375333, member: 571988"] I have an Audiobahn A8000T...its a MONO channel amp. specs are: 400 watts RMS @ 4ohm load 800 watts RMS @ 2ohm load now I have a Treo Engineering 15" sub...its a DVC 2ohm...now technically im only allowed to wire the sub to a 4ohm load for the amp to read. but id like to get 800rms...now here's my question. can i run 2 positive wires from the amp positive to each positive coil on the sub and 2 negative wires from the amp negative to each negative coil? my theory is it would still read a 2ohm load and since both coils are hooked up it would split the power, thus putting 400rms to EACH COIL/ 800RMS total to the subwoofer....any input on this? if not possible no biggy i have a DVC 4ohm sub on the way that i can wire to 2ohm load but i wanted to run my treo in the mean time. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Mono split to stereo?
Top
Menu
What's new
Forum list
