Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
memphis st-300 going into protect
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="gsuchyta" data-source="post: 5082789" data-attributes="member: 585312"><p>After reading a bit on other threads do you think that it's the pre-out voltage is too high from my 880prs which is causing it to clip the signal sending it into protect</p><p></p><p>Also whenever the volume gets to say 34 it will play for a little while then go into protect and I have an rca running on the output side of the memphis amp to another amp and that amp won't get any signal when the memphis is in protect</p><p></p><p>so whatever it is it is clippping the input and ouputs for the rcas</p></blockquote><p></p>
[QUOTE="gsuchyta, post: 5082789, member: 585312"] After reading a bit on other threads do you think that it's the pre-out voltage is too high from my 880prs which is causing it to clip the signal sending it into protect Also whenever the volume gets to say 34 it will play for a little while then go into protect and I have an rca running on the output side of the memphis amp to another amp and that amp won't get any signal when the memphis is in protect so whatever it is it is clippping the input and ouputs for the rcas [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
memphis st-300 going into protect
Top
Menu
What's new
Forum list
