Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Memphis Mojo quad VC problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="NhustlaR" data-source="post: 6372432" data-attributes="member: 562142"><p>I have a 15" mojo quad 1 ohm.. Had it hooked up to an autotek ss1000d (was reading 1.8 going to the amp)</p><p></p><p>I bought a new amp which is 2200@1ohm and heres where the problem started.</p><p></p><p>Had it wired to .8 (should have been 1 ohm) sounded good but it made my amp go into protect after vol 15 (vol 22 is normal)</p><p></p><p>I took the sub out and wired it to 2 ohm (1.8) redid the gains w. a MM and it sounded like it was distorting after approx 1/4 gain.</p><p></p><p>took the sub back out and one VC is not reading. I never checked every VC for resistance, just assumed they were all at 1 ohm. Anyone have suggestions on what could have happened?</p></blockquote><p></p>
[QUOTE="NhustlaR, post: 6372432, member: 562142"] I have a 15" mojo quad 1 ohm.. Had it hooked up to an autotek ss1000d (was reading 1.8 going to the amp) I bought a new amp which is 2200@1ohm and heres where the problem started. Had it wired to .8 (should have been 1 ohm) sounded good but it made my amp go into protect after vol 15 (vol 22 is normal) I took the sub out and wired it to 2 ohm (1.8) redid the gains w. a MM and it sounded like it was distorting after approx 1/4 gain. took the sub back out and one VC is not reading. I never checked every VC for resistance, just assumed they were all at 1 ohm. Anyone have suggestions on what could have happened? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Memphis Mojo quad VC problem
Top
Menu
What's new
Forum list
