Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
Memphis 4kw problem.....look at this video!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="valin" data-source="post: 6118141" data-attributes="member: 567894"><p>I have never seen anything like this before. When the system is powered up, the amp will turn on just fine, but there is no output. It does not kick into protection mode. Even on zero volume, the sub will reach max. excursion very slowly, then pop, and start to move to minimum excursion, and pop again. It will repeat itself over and over. I have tried this on different drivers, at different impedances. The result is the same at all times. It also does not matter where the volume is set.</p><p></p><p>I ran the RCA's from my front channel amp to the Mojo with no change also, and have tried both speaker outputs. Any ideas?</p><p></p><p>Here's the vid....</p><p></p><p><a href="http://s184.photobucket.com/albums/x241/ryanvalin/Tundra%20Sub%20Enclosure%202/?action=view&amp;current=amp001.flv" target="_blank"><img src="http://i184.photobucket.com/albums/x241/ryanvalin/Tundra%20Sub%20Enclosure%202/th_amp001.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /></a></p></blockquote><p></p>
[QUOTE="valin, post: 6118141, member: 567894"] I have never seen anything like this before. When the system is powered up, the amp will turn on just fine, but there is no output. It does not kick into protection mode. Even on zero volume, the sub will reach max. excursion very slowly, then pop, and start to move to minimum excursion, and pop again. It will repeat itself over and over. I have tried this on different drivers, at different impedances. The result is the same at all times. It also does not matter where the volume is set. I ran the RCA's from my front channel amp to the Mojo with no change also, and have tried both speaker outputs. Any ideas? Here's the vid.... [URL="http://s184.photobucket.com/albums/x241/ryanvalin/Tundra%20Sub%20Enclosure%202/?action=view&current=amp001.flv"][IMG]http://i184.photobucket.com/albums/x241/ryanvalin/Tundra%20Sub%20Enclosure%202/th_amp001.jpg[/IMG][/URL] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
Memphis 4kw problem.....look at this video!!
Top
Menu
Home
Refresh