Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Subwoofers
mail me back
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="adamawayfrommpa" data-source="post: 8036" data-attributes="member: 541291"><p>Ok well I have a list for your pioneer sub:</p><p></p><p>********#1----Rockford Fosgate model BD1000.1*********</p><p></p><p>* Class bd technology</p><p></p><p>* 1000 watts x 1 at 2 ohms</p><p></p><p>* 500 watts x 1 at 4 ohms-( I think)</p><p></p><p>* selectable 50-250 Hz variable low-pass crossover, 24 dB/octave</p><p></p><p>* MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability.</p><p></p><p>* TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp.</p><p></p><p>* NOMAD advanced protection circuitry monitors temperature, voltage, current and impedence, and provides "intelligent" shut-down protection without limiting system performance.</p><p></p><p>* preamp outputs for easy connection to a second amplifier</p><p></p><p>* wired remote control of Punch Bass (0-18 dB centered at 45 Hz) — gives you fingertip control of your bass impact</p><p></p><p>* subsonic filter removes frequencies below the range of human hearing for increased efficiency</p><p></p><p>* 100-amp fuse and fuse holder required</p><p></p><p>* dimensions: 14-7/16"W (10-7/8" without endcaps) x 2-7/16"H x 9-7/8"D</p><p></p><p>**********# 2---- Sony XM-3001SXDl*********</p><p></p><p>1000W Max Power (1000W x1 @2OHM )</p><p></p><p>* 500w rms power (500w x1 @4OHM)-( I think)</p><p></p><p>* D-class Amp</p><p></p><p>* Digital Bass and Treble</p><p></p><p>* 21-band Digital Equalizer</p><p></p><p>* 300W x1 into 4O , 5-200kHz, at 0.04% THD</p><p></p><p>********# 3---MTX THUNDER1000D*********</p><p></p><p>RMS POWER (12.5 Volts DC):</p><p></p><p>500 Watts x 1 into a 4 Ohm load with less than 0.5% Thd+N</p><p></p><p>1000 Watts x 1 into a 2 Ohm load with less than 1% Thd+N</p><p></p><p>Dynamic Power (IHF-202 Standard) measured at 14.4 Volts DC</p><p></p><p>850 Watts x 1 into a 4 Ohm load</p><p></p><p>1500 Watts x 1 into a 2 Ohm load</p><p></p><p>Signal to Noise Ratio:</p><p></p><p>100dB A-Weighted</p><p></p><p>Damping Factor:</p><p></p><p>&gt;200</p><p></p><p>Frequency Response:</p><p></p><p>20Hz-200Hz</p><p></p><p>Maximum Input:</p><p></p><p>8Vrms</p><p></p><p>Thunder EQ:</p><p></p><p>Variable Bass Boost (0-18dB) centered at 40Hz</p><p></p><p>EBC External Bass Control</p><p></p><p>Crossover:</p><p></p><p>Variable 40Hz to 200Hz, 24dB/octave low pass</p><p></p><p>Dimensions:14" x 9" x 2" (35.6cm x 22.8cm x 5cm)</p><p></p><p>15-1/4" x 9" x 2" 38.7cm x 22.8cm x 5 cm) Including IsoFeet</p><p></p><p>*******#4---Audiobahn A1500HCX********</p><p></p><p>Amplifier Specifications</p><p></p><p>Amplifier Type: Mono</p><p></p><p>RMS Power: 500W x 1</p><p></p><p>Bridged RMS Power: 1000W x 1</p><p></p><p>THD at Rated RMS Power: 0.02%</p><p></p><p>Speaker Level Inputs: No</p><p></p><p>Preamp Outputs: Yes</p><p></p><p>Built-In Crossovers: HP/LP</p><p></p><p>Bass Boost: 0-18 dB</p><p></p><p>Frequency Response: 10-40,000 Hz</p><p></p><p>Channel Separation: 84 dB</p><p></p><p>Signal to Noise Ratio: &gt; 100 dB</p><p></p><p>Fuse Rating: n/a</p><p></p><p>Well I know that is alot to read but I looked online and I think that any one of the amps I listed would do the job for you very well...These are all high-end amps that may be expensive but are also hig quality....I don't like recommending crap to people...Hope this info helps you..</p><p></p><p>Adam</p><p></p><p>//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif</p></blockquote><p></p>
[QUOTE="adamawayfrommpa, post: 8036, member: 541291"] Ok well I have a list for your pioneer sub: ********#1----Rockford Fosgate model BD1000.1********* * Class bd technology * 1000 watts x 1 at 2 ohms * 500 watts x 1 at 4 ohms-( I think) * selectable 50-250 Hz variable low-pass crossover, 24 dB/octave * MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability. * TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise between the head unit and the amp. * NOMAD advanced protection circuitry monitors temperature, voltage, current and impedence, and provides "intelligent" shut-down protection without limiting system performance. * preamp outputs for easy connection to a second amplifier * wired remote control of Punch Bass (0-18 dB centered at 45 Hz) — gives you fingertip control of your bass impact * subsonic filter removes frequencies below the range of human hearing for increased efficiency * 100-amp fuse and fuse holder required * dimensions: 14-7/16"W (10-7/8" without endcaps) x 2-7/16"H x 9-7/8"D **********# 2---- Sony XM-3001SXDl********* 1000W Max Power (1000W x1 @2OHM ) * 500w rms power (500w x1 @4OHM)-( I think) * D-class Amp * Digital Bass and Treble * 21-band Digital Equalizer * 300W x1 into 4O , 5-200kHz, at 0.04% THD ********# 3---MTX THUNDER1000D********* RMS POWER (12.5 Volts DC): 500 Watts x 1 into a 4 Ohm load with less than 0.5% Thd+N 1000 Watts x 1 into a 2 Ohm load with less than 1% Thd+N Dynamic Power (IHF-202 Standard) measured at 14.4 Volts DC 850 Watts x 1 into a 4 Ohm load 1500 Watts x 1 into a 2 Ohm load Signal to Noise Ratio: 100dB A-Weighted Damping Factor: >200 Frequency Response: 20Hz-200Hz Maximum Input: 8Vrms Thunder EQ: Variable Bass Boost (0-18dB) centered at 40Hz EBC External Bass Control Crossover: Variable 40Hz to 200Hz, 24dB/octave low pass Dimensions:14" x 9" x 2" (35.6cm x 22.8cm x 5cm) 15-1/4" x 9" x 2" 38.7cm x 22.8cm x 5 cm) Including IsoFeet *******#4---Audiobahn A1500HCX******** Amplifier Specifications Amplifier Type: Mono RMS Power: 500W x 1 Bridged RMS Power: 1000W x 1 THD at Rated RMS Power: 0.02% Speaker Level Inputs: No Preamp Outputs: Yes Built-In Crossovers: HP/LP Bass Boost: 0-18 dB Frequency Response: 10-40,000 Hz Channel Separation: 84 dB Signal to Noise Ratio: > 100 dB Fuse Rating: n/a Well I know that is alot to read but I looked online and I think that any one of the amps I listed would do the job for you very well...These are all high-end amps that may be expensive but are also hig quality....I don't like recommending crap to people...Hope this info helps you.. Adam [IMG]//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Subwoofers
mail me back
Top
Menu
Home
Refresh