Reply to thread

Message

<blockquote data-quote="Sharpee64" data-source="post: 8685058" data-attributes="member: 678090">Hi guys my setup is: samsung tab in dash as my headunit, connected to a simulcharge adapter that keeps it charged and allows the tablet to operate in OTG mode. Im using a audioquest dragonfly black (1.2v) 24bit dac as the source. From the dac its currently going to a JL cl-rlc remote level control as my volume knob and from there to my pioneer 5 channel amp. I want to run a line driver to boost the outputHi guys my setup is: samsung tab in dash as my headunit, connected to a simulcharge adapter that keeps it charged and allows the tablet to operate in OTG mode. Im using a audioquest dragonfly black (1.2v) 24bit dac as the source. From the dac its currently going to a JL cl-rlc remote level control as my volume knob and from there to my pioneer 5 channel amp. I want to run a line driver to boost the output voltage from the dac to get a cleaner signal to the amp and still use the Jl remote level control as my volume. With the rlc turned all the way up im still only getting 1.3v output with dmm/scope and a 1000hz sine wave tone? Do i put the line driver before or after the volume control? And how to i go about setting the gains?</blockquote>

[QUOTE="Sharpee64, post: 8685058, member: 678090"] Hi guys my setup is: samsung tab in dash as my headunit, connected to a simulcharge adapter that keeps it charged and allows the tablet to operate in OTG mode. Im using a audioquest dragonfly black (1.2v) 24bit dac as the source. From the dac its currently going to a JL cl-rlc remote level control as my volume knob and from there to my pioneer 5 channel amp. I want to run a line driver to boost the output Hi guys my setup is: samsung tab in dash as my headunit, connected to a simulcharge adapter that keeps it charged and allows the tablet to operate in OTG mode. Im using a audioquest dragonfly black (1.2v) 24bit dac as the source. From the dac its currently going to a JL cl-rlc remote level control as my volume knob and from there to my pioneer 5 channel amp. I want to run a line driver to boost the output voltage from the dac to get a cleaner signal to the amp and still use the Jl remote level control as my volume. With the rlc turned all the way up im still only getting 1.3v output with dmm/scope and a 1000hz sine wave tone? Do i put the line driver before or after the volume control? And how to i go about setting the gains? [/QUOTE]

Verification