Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Miscellaneous Automotive
Car Electronics & Appearance
Lights are flickering after HID install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Effidasus" data-source="post: 6578553" data-attributes="member: 618015"><p>Okay I had asked this in a post I had in the 1st Gen forum but no one has answered so Im going to see if I can get more help in this section. I just got Depo Projector lights and a 6000k HID kit. On the HID wiring there are two wires with tabs that are supposed to run and plug into to the stock harness. Since the Depo lights plug has it setup to run two separate bulbs one for high one for low beam should I clip the two wires running to the low beam and solder in the two wires with the tabs in their place?</p><p></p><p>Or am I completely off base on this?</p><p></p><p>Josh</p></blockquote><p></p>
[QUOTE="Effidasus, post: 6578553, member: 618015"] Okay I had asked this in a post I had in the 1st Gen forum but no one has answered so Im going to see if I can get more help in this section. I just got Depo Projector lights and a 6000k HID kit. On the HID wiring there are two wires with tabs that are supposed to run and plug into to the stock harness. Since the Depo lights plug has it setup to run two separate bulbs one for high one for low beam should I clip the two wires running to the low beam and solder in the two wires with the tabs in their place? Or am I completely off base on this? Josh [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Miscellaneous Automotive
Car Electronics & Appearance
Lights are flickering after HID install
Top
Menu
Home
Refresh