Reply to thread

Message

<blockquote data-quote="BassAddictJ" data-source="post: 5739313" data-attributes="member: 560415">yeah.....i regret selling it....there only about 6in of clearance from the amp top and the trunk ceiling. Cover off the heat dissipates better, its still close enough to the ceiling where its pretty well protected, and the red circuit board is baller. i&#039;m planning on doing an acrylic cover with a larger fan system //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifi tried pressing down/moving slightly the caps at full tilt (wearing protective gloves) to see if it would fix the problem and prove this theory right. Unfortunately the problem persisted and i&#039;m contemplating taking the board out and inspecting it closer. These 2 caps can wiggle a bit while every other cap on the board is solid in place no wiggle. I know i gotta be careful about static electricity when do this too. I just really dont wanna **** with though...i have the input signal turned down a bit and i can still get it full tilt right before the cut out point. unfortunately that requires quite a bit of adjustment and tweaking with each track and i miss the way it was before without having to worry about it cutting out.......at least when its not cutting out i can hear the output difference at 1 ohm. it&#039;s louder //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</blockquote>

[QUOTE="BassAddictJ, post: 5739313, member: 560415"] yeah.....i regret selling it.... there only about 6in of clearance from the amp top and the trunk ceiling. Cover off the heat dissipates better, its still close enough to the ceiling where its pretty well protected, and the red circuit board is baller. i'm planning on doing an acrylic cover with a larger fan system [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] i tried pressing down/moving slightly the caps at full tilt (wearing protective gloves) to see if it would fix the problem and prove this theory right. Unfortunately the problem persisted and i'm contemplating taking the board out and inspecting it closer. These 2 caps can wiggle a bit while every other cap on the board is solid in place no wiggle. I know i gotta be careful about static electricity when do this too. I just really dont wanna **** with though... i have the input signal turned down a bit and i can still get it full tilt right before the cut out point. unfortunately that requires quite a bit of adjustment and tweaking with each track and i miss the way it was before without having to worry about it cutting out.. .....at least when its not cutting out i can hear the output difference at 1 ohm. it's louder [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]

Verification