Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
KX 2500.1 cutting out at 1 ohm :( ?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="BassAddictJ" data-source="post: 5722846" data-attributes="member: 560415"><p>So i've been running my kx 2500.1 @ 2ohm nominal for the last year. i recently reconed the btl to 1 ohm. Now the bass will cut out at and only at full tilt. All connections for power/grounds, speaker wires, and signal wires are solid. Voltage drops typically to 13v, no lower than 12.5v. Input signal voltage is actually slightly lower since the bass eq level is slightly lower to reach full tilt.</p><p></p><p>ive used kx 2500.1's at 1 ohm nominal in the past with the same kind of electrical and never had this issue. lame</p></blockquote><p></p>
[QUOTE="BassAddictJ, post: 5722846, member: 560415"] So i've been running my kx 2500.1 @ 2ohm nominal for the last year. i recently reconed the btl to 1 ohm. Now the bass will cut out at and only at full tilt. All connections for power/grounds, speaker wires, and signal wires are solid. Voltage drops typically to 13v, no lower than 12.5v. Input signal voltage is actually slightly lower since the bass eq level is slightly lower to reach full tilt. ive used kx 2500.1's at 1 ohm nominal in the past with the same kind of electrical and never had this issue. lame [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
KX 2500.1 cutting out at 1 ohm :( ?
Top
Menu
What's new
Forum list
