Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Kicker birth sheet...
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="whitemdx" data-source="post: 1891702" data-attributes="member: 568206"><p>I have a DMM so I will use it to set my gains.</p><p></p><p>sub ch rated @ 420, so I will use that to set the gain, arsenal is dual 4 ohm so i || = 2 ohm load:</p><p></p><p>V = sqrt(420*2) = 28.98V</p><p></p><p>amp 1 &amp; amp 2 will be bridged, rated 165 x 2 @ 4 ohm bridged:</p><p></p><p>V = sqrt (125*4) = 22.36V</p><p></p><p>I am setting it at 125w b/c that seem to be the optimum setting for the 6.5 SLC's from members here on the forum. Or i can just do 4 ohm stereo (70w x 4) and leave amp 2 unloaded for future 6.5 coax for rear fill.</p><p></p><p>Can someone verify my voltage? Also, i planned on using the 80Hz @ -3 db for sub ch and 1KHz @ -3db tones for component set. Thanx.</p></blockquote><p></p>
[QUOTE="whitemdx, post: 1891702, member: 568206"] I have a DMM so I will use it to set my gains. sub ch rated @ 420, so I will use that to set the gain, arsenal is dual 4 ohm so i || = 2 ohm load: V = sqrt(420*2) = 28.98V amp 1 & amp 2 will be bridged, rated 165 x 2 @ 4 ohm bridged: V = sqrt (125*4) = 22.36V I am setting it at 125w b/c that seem to be the optimum setting for the 6.5 SLC's from members here on the forum. Or i can just do 4 ohm stereo (70w x 4) and leave amp 2 unloaded for future 6.5 coax for rear fill. Can someone verify my voltage? Also, i planned on using the 80Hz @ -3 db for sub ch and 1KHz @ -3db tones for component set. Thanx. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Kicker birth sheet...
Top
Menu
What's new
Forum list
