Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Kicker amp goes into protective mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Diesel69" data-source="post: 8728819" data-attributes="member: 681835"><p>Surprisingly, the amp decided to get out from protected mode. All the wires were off except the power, remote and ground of course. Then I connected them one by one to see if the amp would go into protected mode and it didn't. The 2 speakers are working perfect. I don't know why the amp took hours to get out from that. The gains are set to 8o'clock. I checked the ohms and both left and right speakers read close to 4 ohms. Also, the kicker sub reads 4 ohms since it is wired in series.</p><p></p><p>I'm using this <a href="https://www.bestbuy.com/site/rocketfish-30-16-gauge-cm-speaker-wire-gold/6404070.p?skuId=6404070" target="_blank">Rocketfish™ - 30' 16 Gauge CM Speaker Wire - Gold</a> for the sub. Don't know if that even matters. Do you think it is just a defected amp?</p></blockquote><p></p>
[QUOTE="Diesel69, post: 8728819, member: 681835"] Surprisingly, the amp decided to get out from protected mode. All the wires were off except the power, remote and ground of course. Then I connected them one by one to see if the amp would go into protected mode and it didn't. The 2 speakers are working perfect. I don't know why the amp took hours to get out from that. The gains are set to 8o'clock. I checked the ohms and both left and right speakers read close to 4 ohms. Also, the kicker sub reads 4 ohms since it is wired in series. I'm using this [URL='https://www.bestbuy.com/site/rocketfish-30-16-gauge-cm-speaker-wire-gold/6404070.p?skuId=6404070']Rocketfish™ - 30' 16 Gauge CM Speaker Wire - Gold[/URL] for the sub. Don't know if that even matters. Do you think it is just a defected amp? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Kicker amp goes into protective mode
Top
Menu
What's new
Forum list