Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Kenwood going into protect
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="nsstech" data-source="post: 2703711" data-attributes="member: 574465"><p>I recently installed a kenwood 9103D and a pioneer premiere ts-w3004spl into my 99 camaro with 4 gauge power/ground. The DVC woofer is wired in parallel presenting a 2 ohm load to the amp. When it hits hard and the capacitor reads below 11 or 12, the red power light will shut off, and in about 30 seconds it will kick back on. Bass boost on the amp is all the way down. I have tried messing with the input sensivity also. My friends cannot figure this out, neither can I. Any ideas??? one of my friends told me to install another capacitor. This is all with the car running.</p></blockquote><p></p>
[QUOTE="nsstech, post: 2703711, member: 574465"] I recently installed a kenwood 9103D and a pioneer premiere ts-w3004spl into my 99 camaro with 4 gauge power/ground. The DVC woofer is wired in parallel presenting a 2 ohm load to the amp. When it hits hard and the capacitor reads below 11 or 12, the red power light will shut off, and in about 30 seconds it will kick back on. Bass boost on the amp is all the way down. I have tried messing with the input sensivity also. My friends cannot figure this out, neither can I. Any ideas??? one of my friends told me to install another capacitor. This is all with the car running. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Kenwood going into protect
Top
Menu
What's new
Forum list