Reply to thread

Message

<blockquote data-quote="DFW40" data-source="post: 549264" data-attributes="member: 556468">OKTurn signal sensing off.Turn off the infrasonic filter.set the Amp LP filter mode/slope whcih has either 12 or 24db&nbsp; to 24db.set the LP filter to 70 or 80 hzset &quot;Input Voltage&quot; to lowset the input sensitivity as desired and or recommendedDo not worry about the PreAmp output sectionDo you have the remote bass Knob for this amp? If you use it set the &quot;Q&quot; to 1.1set the center freq to 40hz and using the knob will be you &quot;DB&quot;&nbsp; boost. This enables you to adjust the sub&#039;s volume with a quick touch of the knob. Be careful with this because it is a 15db boost which could clip the signal and damage your sub. If you do not have the remote knob I would turn the bass Eq off.Let me know how these settings work for you</blockquote>

[QUOTE="DFW40, post: 549264, member: 556468"] OK Turn signal sensing off. Turn off the infrasonic filter. set the Amp LP filter mode/slope whcih has either 12 or 24db to 24db. set the LP filter to 70 or 80 hz set "Input Voltage" to low set the input sensitivity as desired and or recommended Do not worry about the PreAmp output section Do you have the remote bass Knob for this amp? If you use it set the "Q" to 1.1 set the center freq to 40hz and using the knob will be you "DB" boost. This enables you to adjust the sub's volume with a quick touch of the knob. Be careful with this because it is a 15db boost which could clip the signal and damage your sub. If you do not have the remote knob I would turn the bass Eq off. Let me know how these settings work for you [/QUOTE]

Verification