Reply to thread

Message

<blockquote data-quote="NE14MX" data-source="post: 2208925" data-attributes="member: 558225">Ok I was trying a new setup in my car over the weekend. I was trying a new Arc KAR-900.1 and an Alumapro Alchemy SQ version. It is a DVC 4 ohm sub. I was wanting a 2 ohm load on the amp. There are 2 sets of speaker outputs on that amp. I just used one set to run to the box terminals. From the box terminals, I ran one wire from positive and one wire from negative to one pos and neg post respectively on one of the VC&#039;s on the speaker. Then I ran a wire from the pos post on one VC to teh pos post on teh second VC and did the same thing with the neg. Like this:<a href="http://www.jbl.com/car/support/SubwooferWiring/sub_wiring_diagram.aspx?type=1-4-2" target="_blank">http://www.jbl.com/car/support/SubwooferWiring/sub_wiring_diagram.aspx?type=1-4-2</a>It had almost no volume. sounded terrible. So did I do something wrong with teh speaker terminals at the amp? Any ideas?</blockquote>

[QUOTE="NE14MX, post: 2208925, member: 558225"] Ok I was trying a new setup in my car over the weekend. I was trying a new Arc KAR-900.1 and an Alumapro Alchemy SQ version. It is a DVC 4 ohm sub. I was wanting a 2 ohm load on the amp. There are 2 sets of speaker outputs on that amp. I just used one set to run to the box terminals. From the box terminals, I ran one wire from positive and one wire from negative to one pos and neg post respectively on one of the VC's on the speaker. Then I ran a wire from the pos post on one VC to teh pos post on teh second VC and did the same thing with the neg. Like this: [URL="http://www.jbl.com/car/support/SubwooferWiring/sub_wiring_diagram.aspx?type=1-4-2"]http://www.jbl.com/car/support/SubwooferWiring/sub_wiring_diagram.aspx?type=1-4-2[/URL] It had almost no volume. sounded terrible. So did I do something wrong with teh speaker terminals at the amp? Any ideas? [/QUOTE]

Verification