Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Install quote
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="LosIsATool" data-source="post: 8362132" data-attributes="member: 632125"><p>I'm supplying</p><p></p><p>MS-8</p><p></p><p>Deadener</p><p></p><p>RCAs</p><p></p><p>12awg speaker wire 75ft</p><p></p><p>Big 3 kit</p><p></p><p>Mono block</p><p></p><p>Sub</p><p></p><p>Hertz splits</p><p></p><p>They are suppling</p><p></p><p>4 channel</p><p></p><p>16awg for rear doors and MS-8 signal</p><p></p><p>$500</p><p></p><p>Labor quoted on high side just in case</p><p></p><p>Deaden trunk and seal up front doors done right</p><p></p><p>Build mounts and seals for mids and tweeters done right</p><p></p><p>Run 4 runs of 12awg to the front doors</p><p></p><p>Run 2 runs to rear doors</p><p></p><p>Install MS-8(rear deck) powering rear doors with internal amp</p><p></p><p>Install 4 channel and mono(rear deck)</p><p></p><p>Build box for 8 and carpet</p><p></p><p>Build finish cover for amps and carpet on rear deck after tune is good</p><p></p><p>Install big 3</p><p></p><p>$900</p><p></p><p>I have faith this will be a good install, guy was a old school ISACA player</p><p></p><p>If I get time that I'm not counting on I'll do some of it so this is worse case senerio</p></blockquote><p></p>
[QUOTE="LosIsATool, post: 8362132, member: 632125"] I'm supplying MS-8 Deadener RCAs 12awg speaker wire 75ft Big 3 kit Mono block Sub Hertz splits They are suppling 4 channel 16awg for rear doors and MS-8 signal $500 Labor quoted on high side just in case Deaden trunk and seal up front doors done right Build mounts and seals for mids and tweeters done right Run 4 runs of 12awg to the front doors Run 2 runs to rear doors Install MS-8(rear deck) powering rear doors with internal amp Install 4 channel and mono(rear deck) Build box for 8 and carpet Build finish cover for amps and carpet on rear deck after tune is good Install big 3 $900 I have faith this will be a good install, guy was a old school ISACA player If I get time that I'm not counting on I'll do some of it so this is worse case senerio [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Install quote
Top
Menu
What's new
Forum list