Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
In house bench test
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jackfitz5" data-source="post: 8627036" data-attributes="member: 674561"><p>I am bench testing my setup in my room. My setup is a pioneer head unit wired to two Sony xplod in door speakers. (just left front positive and negative) and same with the right. Then I have the red and yellow wire for the head unit twisted together and go to the positive post of the car battery. Same with the negative. That is all that is wired to my head unit. Then I have two rca cables in the back of the head unit that run to the amp. The amp has positive and negative leads to the same car battery. The turn on wire is wired to the positive so the amp turns on.it is a pioneer amp and the power light turns blue and stays blue. So I would imagine it is not in protect mode. I have this wired to one 4 ohm svc sub. I have the head unit on a setting that allows for rear, sub which is wired speakers and a subwoofer through the rcas. However, when I play a song, the majority of the bass goes through the door speakers. The subs get just enough for me to tell that they are getting anything sent to them. Any advice?</p></blockquote><p></p>
[QUOTE="Jackfitz5, post: 8627036, member: 674561"] I am bench testing my setup in my room. My setup is a pioneer head unit wired to two Sony xplod in door speakers. (just left front positive and negative) and same with the right. Then I have the red and yellow wire for the head unit twisted together and go to the positive post of the car battery. Same with the negative. That is all that is wired to my head unit. Then I have two rca cables in the back of the head unit that run to the amp. The amp has positive and negative leads to the same car battery. The turn on wire is wired to the positive so the amp turns on.it is a pioneer amp and the power light turns blue and stays blue. So I would imagine it is not in protect mode. I have this wired to one 4 ohm svc sub. I have the head unit on a setting that allows for rear, sub which is wired speakers and a subwoofer through the rcas. However, when I play a song, the majority of the bass goes through the door speakers. The subs get just enough for me to tell that they are getting anything sent to them. Any advice? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
In house bench test
Top
Menu
What's new
Forum list