Reply to thread

Message

<blockquote data-quote="agarabaghi" data-source="post: 7281284" data-attributes="member: 632013">I was looking at purchasing this Cadence marine amp, and notice it says Bridged 2 x 300, im guessing peak (since the other numbers say rms). Could i then hook up both channels to the 1 terminal on the Wet Sounds Tower speaker and get approx 600w / 300w rms to them?SQA-41004 CHANNEL STEREO POWER AMPLIFIER*Stainless Steel, rust proof terminals and connections.*Coated PCB and sealed with rubber gaskets.*Marine Grade components, for use in fresh or saltwater environments.*4 ohm RMS power: 4 x 100 Watts*2 ohm RMS power: 4 x 150 Watts*4 ohm Bridged power: 2 x 300 Watts*Frequency Response: 20Hz - 30KHz*S/N Ratio: &amp;gt;65dB*Damping Factor: &amp;gt;200@ 100Hz*Minimum THD:*Full adjustable 12dB Crossover.*Bass Boost Equalization Control.*Large gauge connection terminals.*Input Voltage: 150mV - 5 Volts*Dimensions: 8&quot;(W) x 10.75&quot;(L) x 2.4&quot; (H)*2 Year Warranty</blockquote>

[QUOTE="agarabaghi, post: 7281284, member: 632013"] I was looking at purchasing this Cadence marine amp, and notice it says Bridged 2 x 300, im guessing peak (since the other numbers say rms). Could i then hook up both channels to the 1 terminal on the Wet Sounds Tower speaker and get approx 600w / 300w rms to them? SQA-4100 4 CHANNEL STEREO POWER AMPLIFIER * Stainless Steel, rust proof terminals and connections. * Coated PCB and sealed with rubber gaskets. * Marine Grade components, for use in fresh or saltwater environments. * 4 ohm RMS power: 4 x 100 Watts * 2 ohm RMS power: 4 x 150 Watts * 4 ohm Bridged power: 2 x 300 Watts * Frequency Response: 20Hz - 30KHz * S/N Ratio: >65dB * Damping Factor: >200@ 100Hz * Minimum THD: * Full adjustable 12dB Crossover. * Bass Boost Equalization Control. * Large gauge connection terminals. * Input Voltage: 150mV - 5 Volts * Dimensions: 8"(W) x 10.75"(L) x 2.4" (H) * 2 Year Warranty [/QUOTE]

Verification