Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Hypothetical question regarding in-line high-pass filters
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="GBloes" data-source="post: 8740369" data-attributes="member: 682063"><p>I accidentally ordered 2 sets of 1st order 300hz in-line high-pass filters. Hypothetically, what would happen if I used 2 capacitors per speaker? Based upon my limited knowledge I’m assuming it’d do absolutely nothing other than eat up power, but I was wondering if there’s any way to use them to create a 2nd order high-pass. Even if it changed the crossover frequency.</p><p></p><p>these are just fail safes (the speakers can be crossed over =/>200hz using 2nd order) once I get around to putting in the amp and active crossovers, until then I’m using 850hz in-lines. But if I could use 4 1st order 300hz capacitors to get 2nd order that’d be preferable in the short term.</p></blockquote><p></p>
[QUOTE="GBloes, post: 8740369, member: 682063"] I accidentally ordered 2 sets of 1st order 300hz in-line high-pass filters. Hypothetically, what would happen if I used 2 capacitors per speaker? Based upon my limited knowledge I’m assuming it’d do absolutely nothing other than eat up power, but I was wondering if there’s any way to use them to create a 2nd order high-pass. Even if it changed the crossover frequency. these are just fail safes (the speakers can be crossed over =/>200hz using 2nd order) once I get around to putting in the amp and active crossovers, until then I’m using 850hz in-lines. But if I could use 4 1st order 300hz capacitors to get 2nd order that’d be preferable in the short term. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Hypothetical question regarding in-line high-pass filters
Top
Menu
Home
Refresh