How to use these

[Fender5 10+ year member]

im dont even know what i got. i was hoping it'd be those quick disconnectors. but these arent the same.

http://www.sonicelectronix.com/item_4883_Female+Quick+Disconnect+BLUE+Connectors+.110-+16-14G+-100+Pack-.html

this is what i meant to got. but i have the ones i posted earlier. can i still use them for the same purpose as these

 

[allout13 10+ year member]

You're telling him to put an non-insulated connector into an insulated connector? That pic isnt even the right connectors.

its what I have always used

 

[jdawg 5,000+ posts]

just buy one of those kits for $10 and you will have enough terminals to put together wires like an erector set

 

[James Bang 5,000+ posts]

Here's what you have:

Here is the other half you need:

whooooooohooooooooo

 

[mokedaddy 5,000+ posts]

//content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

Im guessing you are trying to use them on speakers? Crimp the wire in one end, the end with the little hole, press on speaker with other end, clamp down with pliers.

I would recommend against using fork terminals in them though.

 

[Fender5 10+ year member]

the plastic is preventin it from being crimp

 

[timaishu 10+ year member]

You're really making this more difficult than it really is. Just get a pair of pliers and crush it.

Problem solved.

 

[TSGP]

What kind of pliers are you using?

You need a good set of crimpers...

http://www.kleinconnection.com/webapp/wcs/stores/servlet/Category4_10001_10001_-1_12922_J1005_Journeyman™-Crimping-Cutting-Tool-—-Non-Insulated-Insulated-Terminals

I have about 8 pairs of those...they are the essential tool of installing

 

[James Bang 5,000+ posts]

the plastic is preventin it from being crimp

oh my

 

[skittlesRgood 10+ year member]

just smash the **** plastic. if you break through it then use some electrical tape. its a CRIMP they are made to be crimped.

u usualy use these on speaker terminals. should have a spade connector.

im sorry man but anyone that cant figure out a crimp should be added to the moron vote going on in another thread.

 

[rusty_armadillo 10+ year member]

just smash the **** plastic. if you break through it then use some electrical tape. its a CRIMP they are made to be crimped.
u usualy use these on speaker terminals. should have a spade connector.

im sorry man but anyone that cant figure out a crimp should be added to the moron vote going on in another thread.

x2

 

[Fender5 10+ year member]

nah man i know how to crimp. i got the wrong connectors. wantin to see if i could use them anyways. but i can't.

thanks for the replies

 

[helotaxi 5,000+ posts]

I'm guessing that you got those .11" and needed .125" or .25" Send the little bastards to me. I need some of the really little ones.