Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Home Theater & Multi House Speaker Redo & Improvements
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Buck" data-source="post: 8748611" data-attributes="member: 591582"><p>I've gotta use the second zone, which is unused, and I'm going to run a speaker wire to RCA converter on the second zone speaker outputs, and see if I can make a permanent volume control. That's the only audio output I can use for the second receiver for the other speakers.</p><p></p><p>I could use the Zone 2 output and wire that to the 6 zone switchboard, but those zone 2 output will struggle to drive all 6 of those 8 ohm speakers, being that each channel is like 75-100 watts, that'd be like 25w per speaker, which isn't good enough. The second receiver does more power and if I use the setup like a 7.1, then that main receiver will be at full output driving 11 speakers and a sub, that's a lot of stress on that unit.</p></blockquote><p></p>
[QUOTE="Buck, post: 8748611, member: 591582"] I've gotta use the second zone, which is unused, and I'm going to run a speaker wire to RCA converter on the second zone speaker outputs, and see if I can make a permanent volume control. That's the only audio output I can use for the second receiver for the other speakers. I could use the Zone 2 output and wire that to the 6 zone switchboard, but those zone 2 output will struggle to drive all 6 of those 8 ohm speakers, being that each channel is like 75-100 watts, that'd be like 25w per speaker, which isn't good enough. The second receiver does more power and if I use the setup like a 7.1, then that main receiver will be at full output driving 11 speakers and a sub, that's a lot of stress on that unit. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Home Theater & Multi House Speaker Redo & Improvements
Top
Menu
Home
Refresh