Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
holding a box together
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="violator5spd" data-source="post: 135426" data-attributes="member: 545373"><p>i'm going to build a sealed box for my re se's in a week or 2, it should be about 4cu.ft with a divider in the center for added stability. i'll be using a jbl 600.1 running at 1ohm. my question is keeping the box together...would liquid nails &amp; 2inch wood screw every 6in or so be enough? last thing i wanna do is blow the box a little loose. my friends dad was talking about mounting small blocks on the inside to screw into from the outside, but i dont really wanna have to do that unless it's necessary to keep my box together. i dont think it's needed with only 600w, but correct me if i'm wrong cuz i dont' wanna be wrong later...//content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif</p><p></p><p>thanks</p></blockquote><p></p>
[QUOTE="violator5spd, post: 135426, member: 545373"] i'm going to build a sealed box for my re se's in a week or 2, it should be about 4cu.ft with a divider in the center for added stability. i'll be using a jbl 600.1 running at 1ohm. my question is keeping the box together...would liquid nails & 2inch wood screw every 6in or so be enough? last thing i wanna do is blow the box a little loose. my friends dad was talking about mounting small blocks on the inside to screw into from the outside, but i dont really wanna have to do that unless it's necessary to keep my box together. i dont think it's needed with only 600w, but correct me if i'm wrong cuz i dont' wanna be wrong later...[IMG]//content.invisioncic.com/y282845/emoticons/rolleyes.gif.c1fef805e9d1464d377451cd5bc18bfb.gif[/IMG] thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
holding a box together
Top
Menu
Home
Refresh