Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
Hey guys need a hand
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jrizzo1992" data-source="post: 8313057" data-attributes="member: 663029"><p>So I'm on the new side of car audio, and really ( I think) have pretty much the basics down, here's the scenario. A good buddy of mine gave me 2 JL audio 4 ohm single coil 10 inch subs in a sealed box to me, and they work fine( tested them in his car). So I've had a couple subs before and I've blown them- and I think it all comes down to how I've been setting my gains and not knowing how hook the subs up properly. Before I hook these up to my amp I basically want to make sure it's possible to hook them up without risking blowing them, and if it is, how to wire them to the amp,the specifics are:</p><p></p><p>Kenwood KAC-9105D amplifier (mono amp, 900x1 at 2 ohms and 500x1 at 4)</p><p></p><p>2 JL audio 10WXv2 (single coil 4 ohms)</p><p></p><p>Sealed box (not sure of specs)</p><p></p><p>Thanks guys</p></blockquote><p></p>
[QUOTE="Jrizzo1992, post: 8313057, member: 663029"] So I'm on the new side of car audio, and really ( I think) have pretty much the basics down, here's the scenario. A good buddy of mine gave me 2 JL audio 4 ohm single coil 10 inch subs in a sealed box to me, and they work fine( tested them in his car). So I've had a couple subs before and I've blown them- and I think it all comes down to how I've been setting my gains and not knowing how hook the subs up properly. Before I hook these up to my amp I basically want to make sure it's possible to hook them up without risking blowing them, and if it is, how to wire them to the amp,the specifics are: Kenwood KAC-9105D amplifier (mono amp, 900x1 at 2 ohms and 500x1 at 4) 2 JL audio 10WXv2 (single coil 4 ohms) Sealed box (not sure of specs) Thanks guys [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
Hey guys need a hand
Top
Menu
Home
Refresh