Reply to thread

Message

<blockquote data-quote="messyjesse87" data-source="post: 7272550" data-attributes="member: 631790">hey all, new to the forums here!!! Lots of info, but i need some help with my personal setup. I will try to make this as short as possible... I have a 2011 scion tc stock alternator puts out about 90-95 amps, i have a optima yellowtop as well. also will be doing the big 3 with 0 gauge.I am purchasing two alpine type x ten&#039;s that i am going to power with the hifonics brutus 2100 monoblock (recommended by friend) which puts out 2100rms at 1 ohm.I will have the type x&#039;s running down to about 1.3 ohm according to volt meter. This amp has no fuse and i will be utilizing my 250 amp stinger circuit breaker. I will also be running cdt cl pro series 3-way comps in front 2-way in back with a infinity kappa four amp, rated 125w rms x4. This amp has 2 40A fuses on it. I am running all stinger 1/0 gauge from batter to circuit breaker, to a distro block output to 4 gauge to the amps. I also will have a stinger hpc hybrid 30 farad capacitor (got on a steal!) inline to the sub amp. ok here are my questions...1. will my stock electric system handle this set-up i have?2. Will the 250A circuit breaker be enough for this set-up?3. any suggestions to help with my setup/install day???Thanks in advance!!</blockquote>

[QUOTE="messyjesse87, post: 7272550, member: 631790"] hey all, new to the forums here!!! Lots of info, but i need some help with my personal setup. I will try to make this as short as possible... I have a 2011 scion tc stock alternator puts out about 90-95 amps, i have a optima yellowtop as well. also will be doing the big 3 with 0 gauge. I am purchasing two alpine type x ten's that i am going to power with the hifonics brutus 2100 monoblock (recommended by friend) which puts out 2100rms at 1 ohm. I will have the type x's running down to about 1.3 ohm according to volt meter. This amp has no fuse and i will be utilizing my 250 amp stinger circuit breaker. I will also be running cdt cl pro series 3-way comps in front 2-way in back with a infinity kappa four amp, rated 125w rms x4. This amp has 2 40A fuses on it. I am running all stinger 1/0 gauge from batter to circuit breaker, to a distro block output to 4 gauge to the amps. I also will have a stinger hpc hybrid 30 farad capacitor (got on a steal!) inline to the sub amp. ok here are my questions... 1. will my stock electric system handle this set-up i have? 2. Will the 250A circuit breaker be enough for this set-up? 3. any suggestions to help with my setup/install day??? Thanks in advance!! [/QUOTE]

Verification