Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Help with installing components front and rear
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="1aespinoza" data-source="post: 8713466" data-attributes="member: 654802"><p>You already checked that rcas are giving a signal, answer is yes. Checked if amp output on right has power, answer is no. Verdict- amp right channels are bad. If you are certain that right channels are dead, you can do the following. Using only the front rcas, connect Front Left rca to Front Left amp input, now connect Front Right rca to Rear Left amp input. Now bridge Left speakers to Front Left amp output. Finally bridge Right speakers to Rear Left amp output. Amp will see a 2 ohm load so it will put out it's safe rms in stereo mode. </p><p> This way you still have balance available.</p></blockquote><p></p>
[QUOTE="1aespinoza, post: 8713466, member: 654802"] You already checked that rcas are giving a signal, answer is yes. Checked if amp output on right has power, answer is no. Verdict- amp right channels are bad. If you are certain that right channels are dead, you can do the following. Using only the front rcas, connect Front Left rca to Front Left amp input, now connect Front Right rca to Rear Left amp input. Now bridge Left speakers to Front Left amp output. Finally bridge Right speakers to Rear Left amp output. Amp will see a 2 ohm load so it will put out it's safe rms in stereo mode. This way you still have balance available. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Help with installing components front and rear
Top
Menu
Home
Refresh