Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Speakers
Help with installing components front and rear
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ThxOne" data-source="post: 8710569" data-attributes="member: 675210"><p>My two cents...</p><p></p><p>6500's up front.</p><p>6000's out back.</p><p>Make sure the speakers are mounted tight to the door with NO gaps. Use a "rubber like" gasket to mount the speaker to if you can.</p><p>If these speakers were/are new, the 6000's (Stage series) have the capacitor built into the speaker wires that came with the set, this wire is to be run to the tweeter.</p><p>I would run the crossovers full range on the amplifier. They are full range component speaker sets. Use an eq to compensate for any overbearing frequencies.</p><p>The front speakers (Club Series) should be slightly louder than the rear speakers if everything is set the same as they are 3ohm speakers and the rears are 4ohm speakers.</p></blockquote><p></p>
[QUOTE="ThxOne, post: 8710569, member: 675210"] My two cents... 6500's up front. 6000's out back. Make sure the speakers are mounted tight to the door with NO gaps. Use a "rubber like" gasket to mount the speaker to if you can. If these speakers were/are new, the 6000's (Stage series) have the capacitor built into the speaker wires that came with the set, this wire is to be run to the tweeter. I would run the crossovers full range on the amplifier. They are full range component speaker sets. Use an eq to compensate for any overbearing frequencies. The front speakers (Club Series) should be slightly louder than the rear speakers if everything is set the same as they are 3ohm speakers and the rears are 4ohm speakers. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Speakers
Help with installing components front and rear
Top
Menu
What's new
Forum list
