Reply to thread

Message

<blockquote data-quote="rodneypierce" data-source="post: 7647528" data-attributes="member: 639381">They start to sound like *** any lower then what I have them.&nbsp; To me anyhow.&nbsp; This is where its crystal clear, and thats what I was looking for.&nbsp; Thus why I raised the midrange up a little higher to compensate.&nbsp; It currently sounds the best that it has yet.&nbsp; And the 5.25 distorts down that low.&nbsp; It will play that low all day at a medium volume level, and rattle the hell out of the door.&nbsp; But turn up the volume and it is quick to distort.&nbsp; Where I have it set is the cleanest yet still gives some bottom end.&nbsp; And that is why I used a 12db slope instead of a 24db slope on the low pass for the mid.&nbsp; Stretch it out abit more to hopefully pick up a little bit of that 4k range.Fair enough.&nbsp; What would you recommend?&nbsp; And what did you think about that kick panel idea with a midbass, and using the current component set for the high&#039;s.&nbsp; I would be using the passive x-over for them, and running them off the active &quot;high&quot; output.^^&nbsp; This pretty much sums it up!</blockquote>

[QUOTE="rodneypierce, post: 7647528, member: 639381"] They start to sound like *** any lower then what I have them. To me anyhow. This is where its crystal clear, and thats what I was looking for. Thus why I raised the midrange up a little higher to compensate. It currently sounds the best that it has yet. And the 5.25 distorts down that low. It will play that low all day at a medium volume level, and rattle the hell out of the door. But turn up the volume and it is quick to distort. Where I have it set is the cleanest yet still gives some bottom end. And that is why I used a 12db slope instead of a 24db slope on the low pass for the mid. Stretch it out abit more to hopefully pick up a little bit of that 4k range. Fair enough. What would you recommend? And what did you think about that kick panel idea with a midbass, and using the current component set for the high's. I would be using the passive x-over for them, and running them off the active "high" output. ^^ This pretty much sums it up! [/QUOTE]

Verification