Reply to thread

Message

<blockquote data-quote="Immortal" data-source="post: 4239326" data-attributes="member: 584048">From what I have been reading component speakers are the way to go. What size of speakers and baffles should I use in my door hole?Money isnt too much of an issue since I am looking to use EBAY if possible but I want more powerful speakers. The higher the RMS the better.Fosgate makes two POWER 2-way component sets that run at 100 RMS with speaker sizes at 5.25 and 6.5in. Will these fit with baffles in my odd shaped slots?I assume this would not be in the low-mid power category so I suppose at least a small upgrade in amp size would benefit me. I like fosgate as I mentioned so even if I replaced it with a 2 or 4 channel at probably 400 watts (which seems to be the next size up) it probably wouldnt run me more than $200 on EBAY.You mentioned not wanting to underpower, would upgrading the amps (and speakers) overpower it? I mean other than price is there any reason not to upgrade the amp?No I said the 2 subs are wired series parallel so that there is just 1 wire (neg/pos) going to the mono output. Thusly the mono IS powering the subs and the speakers are powered by the 4 channel.&quot;You&#039;ll want to bridge the 4-channel into 2-channels, giving you that &quot;300w&quot; (hehe) of power x2 @ 4ohms.&quot;I thought it already was?</blockquote>

[QUOTE="Immortal, post: 4239326, member: 584048"] From what I have been reading component speakers are the way to go. What size of speakers and baffles should I use in my door hole? Money isnt too much of an issue since I am looking to use EBAY if possible but I want more powerful speakers. The higher the RMS the better. Fosgate makes two POWER 2-way component sets that run at 100 RMS with speaker sizes at 5.25 and 6.5in. Will these fit with baffles in my odd shaped slots? I assume this would not be in the low-mid power category so I suppose at least a small upgrade in amp size would benefit me. I like fosgate as I mentioned so even if I replaced it with a 2 or 4 channel at probably 400 watts (which seems to be the next size up) it probably wouldnt run me more than $200 on EBAY. You mentioned not wanting to underpower, would upgrading the amps (and speakers) overpower it? I mean other than price is there any reason not to upgrade the amp? No I said the 2 subs are wired series parallel so that there is just 1 wire (neg/pos) going to the mono output. Thusly the mono IS powering the subs and the speakers are powered by the 4 channel. "You'll want to bridge the 4-channel into 2-channels, giving you that "300w" (hehe) of power x2 @ 4ohms." I thought it already was? [/QUOTE]

Verification