Reply to thread

Message: <blockquote data-quote="quackhead" data-source="post: 7742804" data-attributes="member: 573547"><p>it appears to be common to a few manufacturers these days... esp. if you can run less than a 2 ohm load. If you have 2 4ohm drivers and wired one to each output, your amp will see a 2ohm load in mono...if just one output is used, make sure it doesn't see less that 2ohms on that amp. now here is the kicker, say you have a 4+4 DVC driver...which output will you use?  confused yet?...six in one, a half dozen in the other.</p></blockquote><p></p>

Top