Reply to thread

Message

<blockquote data-quote="jcgtpafl" data-source="post: 3285795" data-attributes="member: 574657"><p>ok, i just hooked up an orion 2400d amp to ONE of my two power acoustik fubr 10s that i had previously been running both off a m1286i. i just got the (orion) amp today and did a very quick job on hooking it up although i know its all hooked up right as far as the power, ground, and remote wire goes, the problem is that i only plugged in the posi n neg wires to one of the subs, the right one. it plays and all but it sounds WAY different, it will play the higher notes very loud but i can barely hear the lower notes, thats basically the opposite of how they played before on the m1286i. i noticed that the sub thats playing is barely moving, even on low notes, im going to attempt at making a quality install on it in the morning but its very confusing as to what the problem here is. is it that the subs are dual 2 ohms and that they arent wired right in the voicecoils as far as the ohm load goes or something? every bit of advice and/or info would be very much appreciated</p></blockquote><p></p>

[QUOTE="jcgtpafl, post: 3285795, member: 574657"] ok, i just hooked up an orion 2400d amp to ONE of my two power acoustik fubr 10s that i had previously been running both off a m1286i. i just got the (orion) amp today and did a very quick job on hooking it up although i know its all hooked up right as far as the power, ground, and remote wire goes, the problem is that i only plugged in the posi n neg wires to one of the subs, the right one. it plays and all but it sounds WAY different, it will play the higher notes very loud but i can barely hear the lower notes, thats basically the opposite of how they played before on the m1286i. i noticed that the sub thats playing is barely moving, even on low notes, im going to attempt at making a quality install on it in the morning but its very confusing as to what the problem here is. is it that the subs are dual 2 ohms and that they arent wired right in the voicecoils as far as the ohm load goes or something? every bit of advice and/or info would be very much appreciated [/QUOTE]

Verification