Reply to thread

Message

<blockquote data-quote="Fuzion64" data-source="post: 8696088" data-attributes="member: 658588">Setup:Pioneer 6800BS head unit (50x4 RMS)Pioneer AS 6.5&#039;s&nbsp; in front doorsKenwood 9106D Amp (500w RMS@ 4 Ohms | 2000w Peak @ 4 ohms)Memphis Audio SRX 12&quot; shallow mount sub 4 ohms (250w RMS | 500w Peak) in aPrefab box with 0.65 Cuft of airspace for shallow mountHow do I properly configure this when starting from scratch again (Resetting gain and everything)Here is the normal steps I take when configuring1). Find max volume without distortion on headunit (50 of 56)2). Change speaker and sub volumes back 0 (set at 7 on speakers and 5 on sub) Max is 103). Turn off bass boost of 3 to 0 (Typically run this from 1 to 3) Max is 44). Set EQ to flat (Normally runs at powerful setting)5). Set&nbsp; loudness to off (Normally runs on hi or mid)6). Set amp gain to 07). Set lpf to 200hz8). Set isf to 20hz (Sealed enclosure)If I missed a step or I am doing something wrong please tell me. I want to configure this to have the best sound I can get.Play music and turn up gain until bass stops getting louder.Turn down LPF until only bass remainsIncrease all speakers back to 7 and the sub back to 5Set EQ to custom 1 or custom 2-Bring up high ranges slowly (treble)-Bring up mid ranges slowly (vocal)-Bring up low ranges slowly (bass)Is there anything I missed to set this up properly?</blockquote>

[QUOTE="Fuzion64, post: 8696088, member: 658588"] Setup: Pioneer 6800BS head unit (50x4 RMS) Pioneer AS 6.5's in front doors Kenwood 9106D Amp (500w RMS@ 4 Ohms | 2000w Peak @ 4 ohms) Memphis Audio SRX 12" shallow mount sub 4 ohms (250w RMS | 500w Peak) in a Prefab box with 0.65 Cuft of airspace for shallow mount How do I properly configure this when starting from scratch again (Resetting gain and everything) Here is the normal steps I take when configuring 1). Find max volume without distortion on headunit (50 of 56) 2). Change speaker and sub volumes back 0 (set at 7 on speakers and 5 on sub) Max is 10 3). Turn off bass boost of 3 to 0 (Typically run this from 1 to 3) Max is 4 4). Set EQ to flat (Normally runs at powerful setting) 5). Set loudness to off (Normally runs on hi or mid) 6). Set amp gain to 0 7). Set lpf to 200hz 8). Set isf to 20hz (Sealed enclosure) If I missed a step or I am doing something wrong please tell me. I want to configure this to have the best sound I can get. Play music and turn up gain until bass stops getting louder. Turn down LPF until only bass remains Increase all speakers back to 7 and the sub back to 5 Set EQ to custom 1 or custom 2 -Bring up high ranges slowly (treble) -Bring up mid ranges slowly (vocal) -Bring up low ranges slowly (bass) Is there anything I missed to set this up properly? [/QUOTE]

Verification