Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Heat Concerns for Amp Rack
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Kazimir" data-source="post: 7451715" data-attributes="member: 628142"><p>Contents of box:</p><p></p><p>JL HD 600/4</p><p></p><p>JL HD 750/1</p><p></p><p>CarPC</p><p></p><p>MS-8</p><p></p><p>So I am debating between 2 options:</p><p></p><p>1) False floor with 4 inch raise and a semi-complex door system to keep the spare accessible. Best possible heat dispersion, but consumes a good deal of trunk spare and if any spills occur, suseptable to gear getting wet (Unlikely, but possible).</p><p></p><p>2) A 14in x 14in x 14in Box - all products would be mounted on the inside of the box on the 4 side panels, with intake fans on the 4 sides and 1 exhaust fan on the top. All fans are 160mm computer fans. Perk is, this box is effectively waterproof, as it will sit between the sub box and rear seat. This area is effectively dead space as the sub box will block it off. The ground will change from 4.5ft with false floor to about 6in.</p><p></p><p>With that said, will heat be an issue? Setup will be for music listening only. Also, the power cables will be a bit closer to the audio cables. Speaker cable is <a href="http://www.knukonceptz.com/productMaster.cfm?category=KL3%20Kable" target="_blank">Knu KL3</a>. and RCAs will be <a href="http://www.knukonceptz.com/productDetail.cfm?prodID=KRY2.05M" target="_blank">Knu Krystals</a>.</p></blockquote><p></p>
[QUOTE="Kazimir, post: 7451715, member: 628142"] Contents of box: JL HD 600/4 JL HD 750/1 CarPC MS-8 So I am debating between 2 options: 1) False floor with 4 inch raise and a semi-complex door system to keep the spare accessible. Best possible heat dispersion, but consumes a good deal of trunk spare and if any spills occur, suseptable to gear getting wet (Unlikely, but possible). 2) A 14in x 14in x 14in Box - all products would be mounted on the inside of the box on the 4 side panels, with intake fans on the 4 sides and 1 exhaust fan on the top. All fans are 160mm computer fans. Perk is, this box is effectively waterproof, as it will sit between the sub box and rear seat. This area is effectively dead space as the sub box will block it off. The ground will change from 4.5ft with false floor to about 6in. With that said, will heat be an issue? Setup will be for music listening only. Also, the power cables will be a bit closer to the audio cables. Speaker cable is [URL="http://www.knukonceptz.com/productMaster.cfm?category=KL3%20Kable"]Knu KL3[/URL]. and RCAs will be [URL="http://www.knukonceptz.com/productDetail.cfm?prodID=KRY2.05M"]Knu Krystals[/URL]. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Heat Concerns for Amp Rack
Top
Menu
Home
Refresh