hdc3 coils are reading 2-3 ohm?????

[da box king 10+ year member]

Subs are dual 2 ohm. Well I took a reading of my hdc3 wired to my amp, and at the amp it read a 2 ohm load...which it should...everyone is like " you should be fine then"

well I then took the subs out, and all coils are flucuating from 2-3 and normally ending on 2 ohms. My dmm is a greenlee CMT-60 and it does not read to the tenths...it reads to the nearest whole number. Even my sub with what seems to have coil rubbing read 2-3 and ends on 3

All coils are reading the same. Well I'm just not sure, just checkin to see what everyone thought about the situation cuz I'm workin on a trade, I told the guy and he said that its fine.....//content.invisioncic.com/y282845/emoticons/confused.gif.e820e0216602db4765798ac39d28caa9.gif

Click to read more...

 

[Skip01 5,000+ posts]

Touch the leads together and see what they read....they may be off a tad....if its close its good too go

 

[Towncar 10+ year member]

Thats common.. No big deal

 

[da box king 10+ year member]

Touch the leads together and see what they read....they may be off a tad....if its close its good too go

what do you mean the leads...the dmm leads?

just don't want to me trading a bad item:crap:

 

[Skip01 5,000+ posts]

what do you mean the leads...the dmm leads?
just don't want to me trading a bad item:crap:

Yeh...mine read like .2-.3 high, and if ya touch the leads together it usually shows that

But like i said as long as its close its good to go......

 

[da box king 10+ year member]

i connected the pos and neg lead and took my dmm to read and its reading 1

 

[da box king 10+ year member]

Yeh...mine read like .2-.3 high, and if ya touch the leads together it usually shows that
But like i said as long as its close its good to go......

alright man sounds swell...I wish my dmm read tenths, then I could get a more accurate reading

 

[da box king 10+ year member]

well I guess I connect it in parrel instead of series....so it should be reading 1 on a d2

 

[mrogowski 5,000+ posts]

They are definitely faulty. Send them to me since no one would want them like this.

 

[vincer20 10+ year member]

he means to touch the multimeter leads together and it should show the difference you are experiencing