Reply to thread

Message: <blockquote data-quote="SSS 18734" data-source="post: 6525250" data-attributes="member: 559710">Another issue that I didn't pay attention to before was your port. The end of that port is awfully close to the corner of the enclosure - Your sub is seeing a port that is about 5-6 inches longer than you intended it to be (unless you intended the design to be that way).In either case, you should try dropping the port area a bit. 25-35 square inches should be more than adequate. This will also allow the end of the port to be further away from the side of the box.I suppose it could be an issue with the sub itself, but there are a lot of other variables here that could easily be the solution.</blockquote>

Top