1. Products:
2x Digital Design's DD3512C motor and baskets
1x Blown Memphis 16-MCD4kW
2. Specs:
3" Motor, 12" basket. DD rated at 800w RMS. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
Memphis:
1000x1 @ 4 ohms
2000x1 @ 2 ohms
4000x1 @ 1 ohm
3. Descriptions/Condition of all items:
DD's:
I have 2 DD3500C motors and two newer style DD 12spoke baskets. The DD recones cost $89 for D2 and $99 for D1. The baskets need some cleaning still.
Oh yea, notice those nice bolts instead of the
Stupid philips screws that strip //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif
Memphis:
Some scratches on the heatsink. Not bad really. I tried to capture them the best I could. I would say 7.5-8/10
The last owner of the amp must have shorted the terminals on the amp as some of the plastic melted away. I am guessing this is the cause of the amps problems.
The power Supply is blown. Should be around $200 to repair. The amp does power on and the protect light stays green (no protect), the amp does not produce full power however.
I have all the parts as seen in the picture. I can either put the fet clips on or leave them off. Which ever the repair person would like (or buyer). I will be putting the board into the case for safe shipment.
4. Total Price: :
$300 + shipping OBO
5. Pictures:
DD's:
Memphis:
2x Digital Design's DD3512C motor and baskets
1x Blown Memphis 16-MCD4kW
2. Specs:
3" Motor, 12" basket. DD rated at 800w RMS. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif
Memphis:
1000x1 @ 4 ohms
2000x1 @ 2 ohms
4000x1 @ 1 ohm
3. Descriptions/Condition of all items:
DD's:
I have 2 DD3500C motors and two newer style DD 12spoke baskets. The DD recones cost $89 for D2 and $99 for D1. The baskets need some cleaning still.
Oh yea, notice those nice bolts instead of the
Stupid philips screws that strip //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif
Memphis:
Some scratches on the heatsink. Not bad really. I tried to capture them the best I could. I would say 7.5-8/10
The last owner of the amp must have shorted the terminals on the amp as some of the plastic melted away. I am guessing this is the cause of the amps problems.
The power Supply is blown. Should be around $200 to repair. The amp does power on and the protect light stays green (no protect), the amp does not produce full power however.
I have all the parts as seen in the picture. I can either put the fet clips on or leave them off. Which ever the repair person would like (or buyer). I will be putting the board into the case for safe shipment.
4. Total Price: :
$300 + shipping OBO
5. Pictures:
DD's:
Memphis:
