Reply to thread

Message

<blockquote data-quote="DejaWiz" data-source="post: 3138745" data-attributes="member: 569941">It&#039;ll take a bit of work, but it can be done.Memphis 16-XO3 or Profile RX30R (refer to page 4 *manual page 6* of <a href="http://www.profileusa.com/manuals/PX30R.pdf" target="_blank">the OM</a>)Use the Front RCA lineouts from the HU or Line Out Converter.Front MidBass - utilize the 2 sub channels set at LP 400 Hz, set the amp crossover for these to HP 80 Hz.Front MidRange - utilize the 2 band pass channels set for HP 400 Hz and LP 3500 Hz, set the amp crossovers for these to full range/off.Front Highs - use the 2 High channels set at HP 3500 Hz, set the amp crossover for these to rull range/off.Memphis 16-XO3 or Profile RX30RUse the Rear RCA lineouts from the HU or Line Out Converter.Rear MidRange - utilize the 2 bandpass channels set for HP 400 Hz and LP 3500 Hz, set the amp crossover for these to full range/off.Rear Highs - use the 2 High channels set at HP 3500 Hz, set the amp crossover for these to rull range/off.Rear Sub - use the sub channel set to LP 80 Hz.&nbsp; Use the separate sub out from the HU or Line Out Converter if desired.So you&#039;re looking at 1 LOC (DQL-8), 2 XOVERS (models mentioned), and 11 amp channels all in all.&nbsp; There are other ways to do this I&#039;m sure, but I wanted to break it down using items I was familiar with.</blockquote>

[QUOTE="DejaWiz, post: 3138745, member: 569941"] It'll take a bit of work, but it can be done. [B]Memphis 16-XO3 or Profile RX30R[/B] (refer to page 4 *manual page 6* of [URL="http://www.profileusa.com/manuals/PX30R.pdf"]the OM[/URL]) Use the Front RCA lineouts from the HU or Line Out Converter. [B]Front MidBass[/B] - utilize the 2 sub channels set at LP 400 Hz, set the amp crossover for these to HP 80 Hz. [B]Front MidRange[/B] - utilize the 2 band pass channels set for HP 400 Hz and LP 3500 Hz, set the amp crossovers for these to full range/off. [B]Front Highs[/B] - use the 2 High channels set at HP 3500 Hz, set the amp crossover for these to rull range/off. [B]Memphis 16-XO3 or Profile RX30R[/B] Use the Rear RCA lineouts from the HU or Line Out Converter. [B]Rear MidRange[/B] - utilize the 2 bandpass channels set for HP 400 Hz and LP 3500 Hz, set the amp crossover for these to full range/off. [B]Rear Highs[/B] - use the 2 High channels set at HP 3500 Hz, set the amp crossover for these to rull range/off. [B]Rear Sub[/B] - use the sub channel set to LP 80 Hz. Use the separate sub out from the HU or Line Out Converter if desired. So you're looking at 1 LOC (DQL-8), 2 XOVERS (models mentioned), and 11 amp channels all in all. There are other ways to do this I'm sure, but I wanted to break it down using items I was familiar with. [/QUOTE]

Verification