Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Going active.. advice.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="got-one-eight" data-source="post: 6217870" data-attributes="member: 610731"><p>I have decided to remove the bi-amp setup I have and go active with my Morel Elate 6 2W. I am doing this for hopefully more tune ability and better time alignment. This will be my first active setup so I'm not sure where to start. I have an Alpine 9887 and I know I need to flip the switch to 3-way? My question is what is the default head units cut off freq when I flip the switch. I don't want 80hz hitting my tweets of course. Which leads me to my next question.. where should I start on my cutoffs. I know the passive X-over has a 12db slope but not sure what the cutoffs are. I wasnt sure if I should start at 4k hpf on the tweet then how does it work to set the mid up so its playing 80hz-4khz with a 12db slope. Or should I start at 18 to be safe? Also the Front output should be for the tweets and rear should be for the mids correct? I will be running a JL 450/4 to them. 150x2 to the mids and 75x2 to the tweets. Thx for any advice!</p></blockquote><p></p>
[QUOTE="got-one-eight, post: 6217870, member: 610731"] I have decided to remove the bi-amp setup I have and go active with my Morel Elate 6 2W. I am doing this for hopefully more tune ability and better time alignment. This will be my first active setup so I'm not sure where to start. I have an Alpine 9887 and I know I need to flip the switch to 3-way? My question is what is the default head units cut off freq when I flip the switch. I don't want 80hz hitting my tweets of course. Which leads me to my next question.. where should I start on my cutoffs. I know the passive X-over has a 12db slope but not sure what the cutoffs are. I wasnt sure if I should start at 4k hpf on the tweet then how does it work to set the mid up so its playing 80hz-4khz with a 12db slope. Or should I start at 18 to be safe? Also the Front output should be for the tweets and rear should be for the mids correct? I will be running a JL 450/4 to them. 150x2 to the mids and 75x2 to the tweets. Thx for any advice! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Going active.. advice.
Top
Menu
Home
Refresh