Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
General help/ protection mode
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="carter62" data-source="post: 8621577" data-attributes="member: 667462"><p>Im running 2 kicker cvrs 4 ohm DVC to a soundstream T2000.1D, all of my settings (gain log bass boost subsonic) are at half maybe a hair more, I also have a 1 farad capacitor, I followed this wiring diagram for subs, and the capacitor is wired corded and sits at 14. When my bass hits high with the volume up high around 17-20 the amp goes into protection mode just for that hit then back out for lower bass in the song, if I turn it down a click or 2 on volume the song plays fine, all my powers and grounds are 4 gauge and I have 10 gauge speaker wire. Is it possible the hit is making the capacitor go low and killing the amp? Im lost why it only goes into protection for high bass at high volume.[ATTACH]26557145[/ATTACH][ATTACH]26557145[/ATTACH]</p></blockquote><p></p>
[QUOTE="carter62, post: 8621577, member: 667462"] Im running 2 kicker cvrs 4 ohm DVC to a soundstream T2000.1D, all of my settings (gain log bass boost subsonic) are at half maybe a hair more, I also have a 1 farad capacitor, I followed this wiring diagram for subs, and the capacitor is wired corded and sits at 14. When my bass hits high with the volume up high around 17-20 the amp goes into protection mode just for that hit then back out for lower bass in the song, if I turn it down a click or 2 on volume the song plays fine, all my powers and grounds are 4 gauge and I have 10 gauge speaker wire. Is it possible the hit is making the capacitor go low and killing the amp? Im lost why it only goes into protection for high bass at high volume.[ATTACH=CONFIG]26557145[/ATTACH][ATTACH=CONFIG]26557145[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
General help/ protection mode
Top
Menu
Home
Refresh