Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Discussion
Amplifiers
Fusion NV2500 repair
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Zeptoplix" data-source="post: 7135930" data-attributes="member: 580648"><p>So I ordered some parts from Newark to repair my fusion amp.</p><p></p><p>While uninstalling the amp, I was attempting to cut the negative cable, and the positive one came loose and struck the case, causing damage. I took it apart, and found a soot mark on the board and a burned up resistor. I understand visual diagnosis is not all it takes, but for $22 I can attempt to repair and if it does notwork, I'm not really out anything, I can't sell or use the amp now anyways.</p><p></p><p>My question is as follows.</p><p></p><p>I bought the fets, and the resistors. I bought two different ones, as I wasn't sure which ones I needed. So, now I have some 1/4 5% 100ohm resistors (as indicated by color rings) I wasn't sure the wattage so I got the same in a 1W version, 1% tolerance. They are larger, but would fit. albeit differently. Which would should I use? The one thats identical to the original, or the larger lower tolerance unit?</p></blockquote><p></p>
[QUOTE="Zeptoplix, post: 7135930, member: 580648"] So I ordered some parts from Newark to repair my fusion amp. While uninstalling the amp, I was attempting to cut the negative cable, and the positive one came loose and struck the case, causing damage. I took it apart, and found a soot mark on the board and a burned up resistor. I understand visual diagnosis is not all it takes, but for $22 I can attempt to repair and if it does notwork, I'm not really out anything, I can't sell or use the amp now anyways. My question is as follows. I bought the fets, and the resistors. I bought two different ones, as I wasn't sure which ones I needed. So, now I have some 1/4 5% 100ohm resistors (as indicated by color rings) I wasn't sure the wattage so I got the same in a 1W version, 1% tolerance. They are larger, but would fit. albeit differently. Which would should I use? The one thats identical to the original, or the larger lower tolerance unit? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Amplifiers
Fusion NV2500 repair
Top
Menu
What's new
Forum list