Sold FS; Two Old School RF 500X amplifiers

IamMurph
10+ year member

Senior VIP Member
Rating: 0%
0 0 0
These amplifiers were on display for a few years but they haven't seen power very often. Great condition for their age.

21947500269_large.jpg


21947500268_large.jpg


$100 each shipped OBO

62.5 watts RMS x 4 at 4 ohms

125 watts RMS x 4 at 2 ohms

250 watts RMS x 2 at 4 ohms in bridged mode

requires 8-gauge power and ground leads — wiring and hardware not included with amplifier

2-, 3-, or 4-channel output

Tri-way capable (Tri-Way crossover required)

front and rear switchable high-pass (120 Hz, 12 dB/octave) and low-pass (80 Hz, 12 dB/octave) crossovers

MOSFET power supply and output devices

Maximum Efficiency Heat Sink Application (MEHSA) mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability

TOPAZ — noise-killing differential inputs that eliminate 80% of ground loop noise

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

IamMurph

10+ year member
Senior VIP Member
Thread starter
IamMurph
Joined
Location
Rowlett
Start date
Participants
Who Replied
Replies
12
Views
592
Last reply date
Last reply from
lincolntc690
IMG_1882.jpeg

slater

    Oct 4, 2025
  • 0
  • 0
Screenshot_20251004_120904_Photo Translator.jpg

1aespinoza

    Oct 4, 2025
  • 0
  • 0

New threads

Top