Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: Sub, box, 2 amps, amp rack, cap
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="breakinthebeats" data-source="post: 3989936" data-attributes="member: 585099"><p>Here are the specs</p><p></p><p><strong>Sub</strong></p><p></p><p>MTX 9512-44</p><p></p><p>Dual 4ohm</p><p></p><p>Frequency Response - 31-150hz</p><p></p><p>RMS watts - 1000</p><p></p><p>Voice Coil - 4"</p><p></p><p>Magnet weight(oz) - 260</p><p></p><p><strong>Kicker amp</strong></p><p></p><p>Amplifier Class N/A</p><p></p><p>Number of Channels 1 - Mono</p><p></p><p>RMS Power (4 ohms) 500 watts x 1 channel</p><p></p><p>RMS Power (2 ohms) 1000 watts x 1 channel</p><p></p><p>RMS Power (1 ohm) Not Stable</p><p></p><p>Bridged RMS Power Not Bridgeable</p><p></p><p>Peak Power Output N/A</p><p></p><p>Minimum Impedance Unbridged 2 ohms</p><p></p><p>Minimum Impedance Bridged Not Bridgeable ohms</p><p></p><p>THD at Rated RMS Power</p><p></p><p>Speaker Level Inputs Yes</p><p></p><p>Preamp Outputs Yes</p><p></p><p>Built-in Crossover Yes - LP</p><p></p><p>High-Pass Crossover Frequency N/A</p><p></p><p>Low-Pass Crossover Frequency 50 - 200 Hz</p><p></p><p>Subsonic Filter Defeatable @ 25Hz</p><p></p><p>Signal-to-Noise Ratio 95 dB</p><p></p><p>Channel Separation N/A</p><p></p><p>Bass Boost 0 - 18 dB</p><p></p><p>Bass/Gain Remote Yes</p><p></p><p>Fan Cooled N/A</p><p></p><p>Fuse Rating 100A</p><p></p><p><strong>Infinity amp</strong></p><p></p><p>4-channel car amplifier</p><p></p><p>111 watts RMS x 4 at 4 ohms (139 watts x 4 at 2 ohms)</p><p></p><p>278 watts RMS x 2 bridged output at 4 ohms (4-ohm stable in bridged mode)</p><p></p><p>front and rear variable high-/low-pass filters (32-320 Hz, 12 dB/octave)</p><p></p><p>variable bass boost (0-12 dB at 50 Hz)</p><p></p><p>MOSFET power supplies</p><p></p><p>CEA-2006 compliant</p><p></p><p>Tri-way capable (Tri-Way Crossover required)</p><p></p><p>preamp- and speaker-level inputs</p><p></p><p>preamp outputs</p><p></p><p>8-gauge power and ground leads with a 60A fuse recommended — wiring and hardware not included with amplifier</p><p></p><p>fuse rating: 30A x 2</p><p></p><p>16-3/8"W x 2-11/16"H x 12-1/8"D</p></blockquote><p></p>
[QUOTE="breakinthebeats, post: 3989936, member: 585099"] Here are the specs [B]Sub[/B] MTX 9512-44 Dual 4ohm Frequency Response - 31-150hz RMS watts - 1000 Voice Coil - 4" Magnet weight(oz) - 260 [B]Kicker amp[/B] Amplifier Class N/A Number of Channels 1 - Mono RMS Power (4 ohms) 500 watts x 1 channel RMS Power (2 ohms) 1000 watts x 1 channel RMS Power (1 ohm) Not Stable Bridged RMS Power Not Bridgeable Peak Power Output N/A Minimum Impedance Unbridged 2 ohms Minimum Impedance Bridged Not Bridgeable ohms THD at Rated RMS Power Speaker Level Inputs Yes Preamp Outputs Yes Built-in Crossover Yes - LP High-Pass Crossover Frequency N/A Low-Pass Crossover Frequency 50 - 200 Hz Subsonic Filter Defeatable @ 25Hz Signal-to-Noise Ratio 95 dB Channel Separation N/A Bass Boost 0 - 18 dB Bass/Gain Remote Yes Fan Cooled N/A Fuse Rating 100A [B]Infinity amp[/B] 4-channel car amplifier 111 watts RMS x 4 at 4 ohms (139 watts x 4 at 2 ohms) 278 watts RMS x 2 bridged output at 4 ohms (4-ohm stable in bridged mode) front and rear variable high-/low-pass filters (32-320 Hz, 12 dB/octave) variable bass boost (0-12 dB at 50 Hz) MOSFET power supplies CEA-2006 compliant Tri-way capable (Tri-Way Crossover required) preamp- and speaker-level inputs preamp outputs 8-gauge power and ground leads with a 60A fuse recommended — wiring and hardware not included with amplifier fuse rating: 30A x 2 16-3/8"W x 2-11/16"H x 12-1/8"D [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: Sub, box, 2 amps, amp rack, cap
Top
Menu
What's new
Forum list
