Sold FS: Autotek MM4000.1D

[PsychoTheRapist 5,000+ posts]

Autotek MM4000.1D - 7 to 8/10 cosmetic, 10/10 function.

2 X 900 RMS @ 4ohms

2 X 1400 RMS @ 2ohms

2 X 2000 RMS @ 1ohm

1 X 4000 RMS @ 2ohms

600 shipped/insured or BEST!

As always, more pics on request. Thanks for looking. //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

Click to read more...

 

[superbang 10+ year member]

will this run lower then 2ohm MONO ?

 

[PsychoTheRapist 5,000+ posts]

will this run lower then 2ohm MONO ?

Each channel will run 1ohm mono or you can bridge those 2 channels @ 2ohms mono.

 

[PsychoTheRapist 5,000+ posts]

Ttt

 

[SWFL 10+ year member]

anyway to run this amp with 4 dual 2 ohm subs to get 1krms to each sub??

 

[RidnClean 5,000+ posts]

anyway to run this amp with 4 dual 2 ohm subs to get 1krms to each sub??

good question

 

[528hz 10+ year member]

anyway to run this amp with 4 dual 2 ohm subs to get 1krms to each sub??

Well...your wiring options with 4 dual 2 ohm subs is either 1 or .25 ohms. I don't know if these amps like 1 ohm loads or not, but you could get the power out of it if it's possible to put that kind of a load on 'em. With rise you should be fine...

Nice amp too, Sir.

 

[RidnClean 5,000+ posts]

coudl always wire 2 of them to each channel at 2ohms.

they will see like 300 less watts each than if you ran at 2ohms bridged.

 

[TnT_Sounds 10+ year member]

I may have found you a buyer.. Bump for you.

 

[PsychoTheRapist 5,000+ posts]

I may have found you a buyer.. Bump for you.

//content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif Just let me know.

 

[PsychoTheRapist 5,000+ posts]

Lots of interest, but no monies yet.

 

[PsychoTheRapist 5,000+ posts]

Ttt

 

[RidnClean 5,000+ posts]

lmk.

i think i may have cash for you.

 

[PsychoTheRapist 5,000+ posts]

Back in town bump.

 

[PsychoTheRapist 5,000+ posts]

Fml.