Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: 2 MTX 225HO's
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Jason84" data-source="post: 1200151" data-attributes="member: 558810"><p>Thunder225HO Amplifier</p><p></p><p>--------------------------------------------------------------------------------</p><p></p><p>Low impedance, High-Output amplifier.</p><p></p><p>Individual gain controls for left and right.</p><p></p><p>2 sets of RCA connectors.</p><p></p><p>RMS Power measured at 12.5 Volts DC:</p><p></p><p>25 Watts x 2 into a 4 Ohm load with less than 0.05% Thd+N</p><p></p><p>50 Watts x 2 into a 2 Ohm load with less than 0.1% Thd+N</p><p></p><p>100 Watts x 2 into a 1 Ohm load with less than 0.3% Thd+N</p><p></p><p>200 Watts x 2 into a 1/2 Ohm load with less than 0.5% Thd+N</p><p></p><p>400 Watts bridged into a 1 Ohm load with less than 0.5% Thd+N</p><p></p><p>Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC</p><p></p><p>65 Watts x 2 into a 4 Ohm load</p><p></p><p>120 Watts x 2 into a 2 Ohm load</p><p></p><p>200 Watts x 2 into a 1 Ohm load</p><p></p><p>370 Watts x 2 into a 1/2 Ohm load</p><p></p><p>700 Watts bridged into a 1 Ohm load</p><p></p><p>Signal to Noise Ratio:</p><p></p><p>&gt; or =110dB A-Weighted</p><p></p><p>Damping Factor:</p><p></p><p>&gt; 200</p><p></p><p>Frequency Response:</p><p></p><p>20Hz-20kHz ± 0.25dB</p><p></p><p>Dimensions:</p><p></p><p>13" x 9" x 2" (33cm x 22.8cm x 5cm)</p><p></p><p>14-1/4" x 9" x 2" (36.2cm x 22.8cm x 5cm) Including IsoFeet</p><p></p><p>Also Available: Thunder225HO with high gloss white finish</p></blockquote><p></p>
[QUOTE="Jason84, post: 1200151, member: 558810"] Thunder225HO Amplifier -------------------------------------------------------------------------------- Low impedance, High-Output amplifier. Individual gain controls for left and right. 2 sets of RCA connectors. RMS Power measured at 12.5 Volts DC: 25 Watts x 2 into a 4 Ohm load with less than 0.05% Thd+N 50 Watts x 2 into a 2 Ohm load with less than 0.1% Thd+N 100 Watts x 2 into a 1 Ohm load with less than 0.3% Thd+N 200 Watts x 2 into a 1/2 Ohm load with less than 0.5% Thd+N 400 Watts bridged into a 1 Ohm load with less than 0.5% Thd+N Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC 65 Watts x 2 into a 4 Ohm load 120 Watts x 2 into a 2 Ohm load 200 Watts x 2 into a 1 Ohm load 370 Watts x 2 into a 1/2 Ohm load 700 Watts bridged into a 1 Ohm load Signal to Noise Ratio: > or =110dB A-Weighted Damping Factor: > 200 Frequency Response: 20Hz-20kHz ± 0.25dB Dimensions: 13" x 9" x 2" (33cm x 22.8cm x 5cm) 14-1/4" x 9" x 2" (36.2cm x 22.8cm x 5cm) Including IsoFeet Also Available: Thunder225HO with high gloss white finish [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
CarAudio.com Classifieds
Car Audio Classifieds
FS: 2 MTX 225HO's
Top
Menu
What's new
Forum list