Sold FS: 2 15" Konaki w/ CF cone, cap, flat wind, high roll surround D1

BushJ311
5,000+ posts

CarAudio.com Veteran
Rating: 0%
0 0 0
got these built with the intent to use them. Everything went wrong and I am with out a car and need cash to get something decent.

They are 15"

konaki motors

dual 1 ohm

high roll surround

carbon fiber cone and cap

flat wind coils

3" coil

300 oz motor

built by woofercooker

over 50 pounds each

That is all i know. If you need more info I will try to find it out.

one has some glue or something on the boot and on the same one the basket has some black stuff on it.

Price is 315 shipped each

Trades: Partial only. Battery or 1/0 wire

Konaki001.jpg


Konaki003.jpg


Konaki004.jpg


Konaki006.jpg


Konaki008.jpg


av002.jpg


 
yea when you make a custom sub and put an rms on it why wouldnt you make it the maximum amount it can handle daily?

1500 rms but can take more just sounds dumb to me

 
yea when you make a custom sub and put an rms on it why wouldnt you make it the maximum amount it can handle daily?
1500 rms but can take more just sounds dumb to me
I think it'd be a much better idea to rate it conservatively than over rate it and the buyer blows it assuming it can handle that much and then comes back after the seller.

Much easier to just rate it conservatively and let the buyer push it to the limit on his own terms. Not at the risk of the seller.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

BushJ311

5,000+ posts
CarAudio.com Veteran
Thread starter
BushJ311
Joined
Location
NW, PA
Start date
Participants
Who Replied
Replies
28
Views
1,315
Last reply date
Last reply from
DNick454
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0
IMG_2118.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top