For sale are 2 almost new Atomic amps, an AT 1600.1D and Trinity 504. I am staying with only ZED audio amps and have no more use for these anymore. They were purchased on 10/6/08 brand new from Atomic and work perfectly and have barely been used. The specs for both amps are listed below. I am asking $520 shipped for both.
Digital mono block amplifier
* Dual MOS-FET power supplies
* Efficiency over 86%
* RMS power handling---430w @ 4 ohms @14.4V
* RMS power handling---850w @ 2 ohms @14.4V
* RMS power handling---1650w @ 1 ohms @14.4V
* Signal-to-noise ratio 85dB
* Phase shift 0-180 degree
* subsonic filter: 10-60Hz
* lowpass filter: 35-300Hz
* Input sensitivity: 200mV -6V
* Bass remote controller with telephone wire & click volume & blue LED
* 3 way protection: over voltage, speaker short & thermal overload
* Total harmonic distortion:
* Continuously variable 0 – 18dB Bass Boost
* Built - in variable 0 – 18dB per octave x’over
* Power Consumption
* Size: 17.0” x 10” x 2.20”
Stable into 4 ohms bridged or 2 ohms load workable
* 2 ohms bridged load workable at music playing
* matched Bi-Polar output transistors
* dual transformer
* 12 dB low pass and high pass crossover
* 18 dB bass boost equalization variable control
* Input sensitivity variable: 7V – 250mV
* 3 way protection Circuit: over voltage, speaker short and thermal overload
* S/N ratio :> 105dB
* THD:
* size – 9.0” x2.50” x 11.8”
Digital mono block amplifier
* Dual MOS-FET power supplies
* Efficiency over 86%
* RMS power handling---430w @ 4 ohms @14.4V
* RMS power handling---850w @ 2 ohms @14.4V
* RMS power handling---1650w @ 1 ohms @14.4V
* Signal-to-noise ratio 85dB
* Phase shift 0-180 degree
* subsonic filter: 10-60Hz
* lowpass filter: 35-300Hz
* Input sensitivity: 200mV -6V
* Bass remote controller with telephone wire & click volume & blue LED
* 3 way protection: over voltage, speaker short & thermal overload
* Total harmonic distortion:
* Continuously variable 0 – 18dB Bass Boost
* Built - in variable 0 – 18dB per octave x’over
* Power Consumption
* Size: 17.0” x 10” x 2.20”
Stable into 4 ohms bridged or 2 ohms load workable
* 2 ohms bridged load workable at music playing
* matched Bi-Polar output transistors
* dual transformer
* 12 dB low pass and high pass crossover
* 18 dB bass boost equalization variable control
* Input sensitivity variable: 7V – 250mV
* 3 way protection Circuit: over voltage, speaker short and thermal overload
* S/N ratio :> 105dB
* THD:
* size – 9.0” x2.50” x 11.8”
