Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Flared ports...how you do that
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="spltuscon" data-source="post: 6438917" data-attributes="member: 611863"><p>Basically what was said above...</p><p></p><p>Transmission line is typically tapered from an area greater than the sd of the sub down to the sd at the Terminus (the opening). You can vary the ratio of the line to change the acoustic properties of the enclosure. The line length is based on the 1/4, 1/2, or 3/4 length of the "tuning frequency" (ideally tuned to the drivers fs or just above). You can also stuff the line to slow down the sound waves and get a longer effective line length. Stuffing the line also lowers the impedance spike.</p><p></p><p>Sound wise, they are very clean and tight, similar to a sealed box (good transient response) but the output is very similar to a ported box. The low end roll-off is much shallower than a ported box also, so they do very well on the lows.</p><p></p><p>Of coarse there is more to it, but that's the basics //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif</p></blockquote><p></p>
[QUOTE="spltuscon, post: 6438917, member: 611863"] Basically what was said above... Transmission line is typically tapered from an area greater than the sd of the sub down to the sd at the Terminus (the opening). You can vary the ratio of the line to change the acoustic properties of the enclosure. The line length is based on the 1/4, 1/2, or 3/4 length of the "tuning frequency" (ideally tuned to the drivers fs or just above). You can also stuff the line to slow down the sound waves and get a longer effective line length. Stuffing the line also lowers the impedance spike. Sound wise, they are very clean and tight, similar to a sealed box (good transient response) but the output is very similar to a ported box. The low end roll-off is much shallower than a ported box also, so they do very well on the lows. Of coarse there is more to it, but that's the basics [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Flared ports...how you do that
Top
Menu
What's new
Forum list