Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
First time Installation help. Alpine Audio Control LC2i
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Seatssuck" data-source="post: 8405797" data-attributes="member: 664361"><p>Hello,</p><p></p><p>I have a 2009 Acura TL and I want to put a subwoofer in it. I have a 500W speaker at 2 ohm, an Alpine MRP-M500 mono amp, and an Audio Control LC2i.</p><p></p><p>Will an 8ga power wire (required by this version amp) be enough to run the amp and the LC2i? I'm assuming the LC2i will not need much power. I want to run the power wire all the way to the back and then put a distribution block to go into the LC2i. I believe it needs a 12ga power and ground.</p><p></p><p>Thanks for any help.</p><p></p><p>This is the first of two cars I'll be doing this week. I'll be treating doors and installing components on the other car. My first install, I'm sure i'll be hooked after this.</p></blockquote><p></p>
[QUOTE="Seatssuck, post: 8405797, member: 664361"] Hello, I have a 2009 Acura TL and I want to put a subwoofer in it. I have a 500W speaker at 2 ohm, an Alpine MRP-M500 mono amp, and an Audio Control LC2i. Will an 8ga power wire (required by this version amp) be enough to run the amp and the LC2i? I'm assuming the LC2i will not need much power. I want to run the power wire all the way to the back and then put a distribution block to go into the LC2i. I believe it needs a 12ga power and ground. Thanks for any help. This is the first of two cars I'll be doing this week. I'll be treating doors and installing components on the other car. My first install, I'm sure i'll be hooked after this. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
First time Installation help. Alpine Audio Control LC2i
Top
Menu
Home
Refresh