Reply to thread

Message

<blockquote data-quote="Pioneer~Saturn" data-source="post: 5395237" data-attributes="member: 569334">I would strongly recommend titebond II and 1 5/8&quot; drywall screws (coarse thread)...then once its all done and you arent sure if its sealed you could put a run of clear silicon along each seam on the inside of the enclosure.As for the double baffle, try this....put the two sheets ontop of eachother and hold them firm so they dont slide...in two opposite corners/areas of the boards drill holes through the first sheet and a bit into the next sheet...then lay down some wood glue all over the top of the second sheet (inbetween the sheets)Now, put the top sheet back on and take 1 1/4&quot; drywall screws and tighten them down into those two holes...no go about drilling holes and tightening screws throughout the boards so theyre held together...this will hold them together and the 1 1/4&quot; screws wont poke ou the other side //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gifLike this (for just two sheets)..<img src="http://i474.photobucket.com/albums/rr102/DougRoosa/DSCN2051.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" />Or this if your doing sheets that involve mounting a sub/sountersinking a sub..<img src="http://i474.photobucket.com/albums/rr102/DougRoosa/4.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /></blockquote>

[QUOTE="Pioneer~Saturn, post: 5395237, member: 569334"] I would strongly recommend titebond II and 1 5/8" drywall screws (coarse thread)...then once its all done and you arent sure if its sealed you could put a run of clear silicon along each seam on the inside of the enclosure. As for the double baffle, try this....put the two sheets ontop of eachother and hold them firm so they dont slide...in two opposite corners/areas of the boards drill holes through the first sheet and a bit into the next sheet...then lay down some wood glue all over the top of the second sheet (inbetween the sheets) Now, put the top sheet back on and take 1 1/4" drywall screws and tighten them down into those two holes...no go about drilling holes and tightening screws throughout the boards so theyre held together...this will hold them together and the 1 1/4" screws wont poke ou the other side [IMG]//content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif[/IMG] Like this (for just two sheets).. [IMG]http://i474.photobucket.com/albums/rr102/DougRoosa/DSCN2051.jpg[/IMG] Or this if your doing sheets that involve mounting a sub/sountersinking a sub.. [IMG]http://i474.photobucket.com/albums/rr102/DougRoosa/4.jpg[/IMG] [/QUOTE]

Verification