Reply to thread

Message

<blockquote data-quote="bustaplz" data-source="post: 5894943" data-attributes="member: 567655">Lol, well my friend has his heart set on a 12&quot; Q. I&#039;m really thinking it won&#039;t fit, it&#039;s a very small space. He hasn&#039;t bought the subwoofer yet so I can&#039;t get measurements off it and the truck is his so I&#039;m doing all the trial and error in sketch-up because I can&#039;t just walk outside and check a measurement real quick.I also don&#039;t want to do trial and error when building it because it is his money and not mine. I don&#039;t want him to order the driver until I have a design that will work for sure. How far does the surround stick out from the baffle? If it&#039;s more than about an inch, it will most likely hit the backs of the seats, but if the box is any more shallow, the motor will be against the back wall. I&#039;m almost tempted to just order the **** thing so I can measure it! I assume the basket width is about the same as the cutout diameter? Can you tell me how deep that measurement goes? The basket will most likely not fit between the seats, but the motor should have plently of room. Think you could give me the motor depth?I&#039;m thinking the mounting hole ring and gasket probably add 1/4&quot;-1/2&quot; to the depth if mounted inverted, so if the motor depth is maybe 3.5-4&quot; I may be able to design the box to be a bit more shallow and allow the basket to clear the seats.</blockquote>

[QUOTE="bustaplz, post: 5894943, member: 567655"] Lol, well my friend has his heart set on a 12" Q. I'm really thinking it won't fit, it's a very small space. He hasn't bought the subwoofer yet so I can't get measurements off it and the truck is his so I'm doing all the trial and error in sketch-up because I can't just walk outside and check a measurement real quick. I also don't want to do trial and error when building it because it is his money and not mine. I don't want him to order the driver until I have a design that will work for sure. How far does the surround stick out from the baffle? If it's more than about an inch, it will most likely hit the backs of the seats, but if the box is any more shallow, the motor will be against the back wall. I'm almost tempted to just order the **** thing so I can measure it! I assume the basket width is about the same as the cutout diameter? Can you tell me how deep that measurement goes? The basket will most likely not fit between the seats, but the motor should have plently of room. Think you could give me the motor depth? I'm thinking the mounting hole ring and gasket probably add 1/4"-1/2" to the depth if mounted inverted, so if the motor depth is maybe 3.5-4" I may be able to design the box to be a bit more shallow and allow the basket to clear the seats. [/QUOTE]

Verification